Network (Tcp/Ip) Settings - Kyocera KM-4530 Operation Manual

2. Set-up

2-4 Network (TCP/IP) settings

To use the printer as a network printer, it is necessary to set an IP
address for the printer.
Notes
• The IP address that should be registered here will differ depending
upon your network environment. Check with your network
administrator BEFORE performing this setting.
• If you are using a DHCP server to automatically configure the IP
address, this setting will not be necessary because DHCP server
configuration is already enabled as the factory default setting.
* To cancel the setting midway through it, press the Stop/Clear key.
1 Press the Printer key. The printer will switch to the printer
mode.
2 Touch the "Printer Menu" key.
Touch the "Interface" key.
3
4 Touch the "Network" key and then the "Detail" key.
6
Use the "L" and "M" cursor keys to select "TCP/IP" and
5
then touch the "Change" key.
6 Select "ON" under the "TCP/IP" setting and "OFF" under the
"DHCP" setting.
Use the "L" and "M" cursor keys to select "IP Address" and
7
then touch the "Change" key.
8 Use the numeric keys to input the address. Input the first
block of 3 digits of the address in the highlighted area.
• Press the sharp (#) key to set the address after inputting
each block of 3 digits.