Eicon Networks 1530 User Manual page 139

SET IP SERVICES { ALL | INTELLIGENT | MINIMAL | NONE}
Defines the level of support provided for Microsoft NetBIOS services, which are integrated
into Microsoft TCP/IP. NetBIOS is required to support Microsoft Windows Network
Neighborhood, the MAP NETWORK option in Windows Explorer, and various DOS-based
networking commands (such as net use, net view, and net logon). Default: ALL.
ALL: All NetBIOS traffic is forwarded to the remote site. This may result in substantial
connection charges unless you have a flat rate connection, as outgoing calls will be made
frequently.
INTELLIGENT: Provides full support for all Network Neighborhood functions, but spoofs
unnecessary traffic to reduce usage.
MINIMAL: Reduces NetBIOS traffic to a minimum. Does not support Network Neighborhood
functions. However, the MAP NETWORK option in Windows Explorer is supported, along
with DOS-based networking commands such as net use, net view, and net logon. This is the
most economical solution.
NONE: All NetBIOS traffic is discarded.
ENABLE IP SPOOFING
DISABLE IP SPOOFING
Enables/disables spoofing. When enabled, all TCP keep-alive datagrams and all Microsoft
Server Message Block datagrams are spoofed. In addition, all NetBIOS over IP name service
traffic is dropped.
Default: Enabled.
ENABLE IP BROADCAST
DISABLE IP BROADCAST
Enables/disables support for IP broadcasting.
Default: Disabled.
ENABLE IP MULTICAST
DISABLE IP MULTICAST
Enables/disables support for IP multicasting. When disabled, IP multicast datagrams are not
forwarded from the external network onto the internal Ethernet LAN. To allow computers on
the internal LAN to subscribe to services that use IP multicasting as a delivery mechanism, you
must enable this option.
Default for internal LAN: Enabled. Default for each profile: Disabled.
ENABLE IP MANUALDIAL
DISABLE IP MANUALDIAL
Enables/disables manual dialing of this profile. With manual dialing enabled, this profile will
NOT be automatically connected when data needs to be sent. Instead, you must manually
connect the profile. Use the DIAL command to dial the profile manually.
ENABLE IP UNNUMBERED
DISABLE IP UNNUMBERED
Enables/disables IP Unnumbered Mode for this profile. This saves an IP address by using the
same IP address for both the external network and internal LAN. This option is valid only if
NAT is NOT enabled.
Command Line Interface 139