Table of Contents
Advertisement
SET FRELAY LMIT1 { 5 | 10 | 15 | 20 | 25 | 30 }
Defines how frequently the Eicon 1530 should initiate a Status Enquiry message. This timer
must be set to less than the timer used by the Frame Relay Network to verify that the Eicon
1530 is sending Status Enquiry messages. To determine the Frame Relay Network timer value,
contact your network administrator.
Possible values: 5, 10, 15, 20, 25, 30 (seconds).
Default value: Every 10 seconds.
SET FRELAY N1 fieldsize
Defines the maximum number of bytes of user data that can be contained in a Frame Relay
frame.
Range: 19-4096.
Default value: 1514.
SET FRELAY WINDOWSIZE k
Defines the Frame Relay window size for all discovered DLCIs on a given Frame Relay
connection, which determines the number of packets that can be sent before waiting for an
acknowledgment. Only applicable if Dynamic DLCI is enabled. Used for transmission buffer
control.
Range: 1-255.
Default: 2.
You can enable Dynamic DLCI using SET FRELAY DLCIMODE DYNAMIC.
SHOW FRELAY CONFIGURATION
Displays Frame Relay configuration settings.
SHOW FRELAY STATISTICS
Displays Frame Relay statistics.
SHOW FRELAY STATUS
Displays Frame Relay status.
SHOW FRELAY TRACE [mask [memsize [framesize]]]
Starts a Frame Relay trace, or displays an active trace.
mask:
01 Data frame
02 LMI frame
memsize: The amount of RAM reserved to store the trace on the Eicon 1530 WAN Router.
Range: 1-63 KB. Default: 16 KB
framesize: Number of characters to show for each frame.
Range: 64-1024 KB. Default: 128 KB
Note: If entered 0 or nothing the default value will be used.
STOP FRELAY TRACE
Stops an active Frame Relay trace.
Command Line Interface
128
Advertisement
Table of Contents
