Asus M2A-MVP - Motherboard - ATX User Manual page 70

TRRD [Auto]
Configuration options: [Auto] [2T] [3T] [4T] [5T]
TRC [Auto]
Configuration options: [Auto] [11T] [12T] [13T]~[26T]
Bank Interleaving [Auto]
Sets to [Auto] or disables the Bank Memory Interleaving.
Configuration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled]
Enables or disables the unused clocks to DIMMs.
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ATLVID [Disabled]
Enables or disables the MemClk Tri-Stating during C3 and Alt VID.
Configuration options: [Disabled] [Enabled]
Memory Hole Remapping [Enabled]
Enables or disables the Memory Remapping around Memory Hole.
Configuration options: [Disabled] [Enabled]
ECC Configuraiton
Advanced
ECC Controller
DRAM ECC Enable
4-Bit ECC Mode
DRAM SCRUB REDIRECT
DRAM BG Scrub
L2 Cache BG Scrub
Data Cache BG Scrub
DRAM ECC Enable [Enabled]
Allows you to enable or disable DRAM ECC, which allows the hardware to
report and correct memory errors automatically to maintain system integrity.
Configuration options: [Disabled] [Enabled]
4-Bit ECC Mode [Disabled]
Enables or disables the 4-bit ECC mode.
Configuration options: [Disabled] [Enabled]
DRAM SCRUB REDIRECT [Disabled]
Allows you to enable or disable DRAM scrub redirect, which allows the system
to correct DRAM ECC errors immediately when they occur, even if background
scrubbing is on. Configuration options: [Disabled] [Enabled]
2-22
[Auto]
BIOS SETUP UTILITY
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
Select the DRAM
Frequency programming
method. If Auto,
the DRAM speed will
be based on SPDs.
If Limit, the DRAM
speed will not exceed
the specified value.
If Manual, the DRAM
specified will be
programmed regardless
Chapter 2: BIOS setup