Asus M2A-MVP - Motherboard - ATX User Manual page 41

Single device
Two devices
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
3. Serial ATA connectors
(7-pin SATA1[red], SATA2 [red], SATA3 [black], SATA4 [black]
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can can create a
RAID �, RAID 1, and RAID ��1 configuration. Refer to Chapter 3 for
information on creating a RAID configuration.
Enable the Serial ATA Controller and Onboard SATA Boot ROM items in the
BIOS if you want to use the Serial ATA RAID feature. See section 2.3.5 Storage
Configuration for details.
M2A-MVP
M2A-MVP
M2A-MVP
M2A-MVP SATA connectors
M2A-MVP SATA connectors
M2A-MVP SATA connectors
ASUS M2A-MVP
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
SATA2
SATA4
Mode of Cable connector
device(s)
Black
—
Black
Master
Slave Gray
Master
Black or gray
Slave
SATA2 SATA1
SATA1
SATA2 SATA1
SATA4 SATA3
SATA3
SATA4 SATA3
1-29