Connecting The Expansion Base To A Network; Using The Security Cable Locks - HP Compaq NX9100 Reference Manual

Using the Expansion Base
Connecting the Expansion Base to a
Network
You can connect your notebook through the Expansion Base to a
network. This requires an RJ-45 network cable (purchased
separately).
1. If you haven't already done so, connect the Expansion Base
to your notebook following the instructions in the
"Connecting and Removing the Notebook"
guide.
2. Connect one end of the network cable to the RJ-45 jack on
the Expansion Base and the other end to the RJ-45 wall jack.
An RJ-11 modem cable between the notebook and Expansion
Base is not required if connecting directly to a network.

Using the Security Cable Locks

The purpose of security solutions is to act as a deterrent. These
solutions do not prevent the product from being mishandled or
stolen.
1. With the notebook positioned in the Expansion Base, loop the
security cable (purchased separately) around a secure object;
then insert the lock into the security cable slot on the
Expansion Base.
3–10
Use the RJ-45 connector on the Expansion Base instead of
the one on the notebook. The RJ-45 connector on some
notebooks may be disabled when the notebook is installed
in the Expansion Base.
chapter in this
Reference Guide