Connecting Port Modules To Mux 64 Card; Install The Ps-4 Power Supplyinstall The Mux Power Supply - HP EISA/PCI Multiplexer Manual

Figure 7 Coupling and wall mounting two port modules
3. Also included with each port module are two wall mounting brackets and four screws. Attach
the mounting brackets to the appropriate modules and secure them to a surface as shown in
Figure 3-2 insert.
NOTE: To wall mount a single module, attach one bracket on the top and one bracket on
the bottom at opposite sides of the module.

Connecting Port Modules to Mux 64 Card

Connect port modules to the Mux 64 Card using the supplied host cable, J2483-60013 (4-feet)
or 3595-63001 (25-feet) or one you have made (see Appendix A).
A maximum of 4 port modules can be connected to the host cable as shown in Figure 3-3.
Figure 8 Port module HD-26 male connector
Install the Mux Power Supply
Install the power supply for the Mux port modules (see Figure 3-4) using the following procedure:
Install the Mux Power Supply 13