Mounting Touch Panel - Panasonic TY-TP42P10S - Touch-screen - Wired Operating Instructions Manual

Mounting Touch Panel

Attach mounting brackets to the touch panel.
1

Fit the protrusion located above the round hole on mounting bracket A into the hole of the top unit and
then tighten mounting screw A by hand.

As shown in the diagram, tighten mounting screw A by hand to hold mounting bracket B temporarily
after fi tting the protrusion located above the round hole on the mounting bracket B into the hole of the
bottom unit. Screw mounting screw A into the hole of the bottom unit half way.
Protrusions
Mounting
screws A
Screw
Mounting bracket A
Attach the touch panel to the front of the plasma display.
2

Notes on Assembly
• Work in two or more to attach the touch panel to the plasma
display. If the touch panel is dropped, injuries may occur.
• Because it can damage the infrared sensor of the touch panel, do
not lay the touch panel down and attach the plasma display to it
from above. Service for damage caused by installation in this way
is subject to billing.
Plasma display
Touch panel
(in Horizontal Posture)
Screw in
halfway
Mounting
screws A
Screw
Mounting bracket B

Protrusion
INCORRECT
Floor
9