Panasonic TY-TP42P10S - Touch-screen - Wired Operating Instructions Manual page 11

Mounting Touch Panel
Attach mounting brackets to the touch panel.
1

Fit the protrusions on the vertical mounting brackets into the holes of the unit and affi x the brackets
with mounting screws B.

As shown in the diagrams, tighten mounting screws A by hand to temporarily hold the brackets A and B
after fi tting the protrusions located above the round holes on both brackets into the holes of the top and
bottom units. Screw mounting screws A into the top and bottom units half way.
Screw in halfway
Mounting
screws A
Attach the touch panel to the front of the plasma display.
2

To attach the touch panel to the plasma display, align the top and bottom edges of the touch panel
with the top and bottom edges of the plasma display. Once attached, adjust the fi t so that the left and
right black frames on the front of the plasma display are the same width.
Vertical mounting brackets
Mounting screws B

Protrusion
Mounting
bracket A
Top unit
Notes on Assembly
• Work in twos or more to attach the touch panel to the plasma display. If the
touch panel is dropped, injuries may occur.
• Because it can damage the infrared sensor of the touch panel, do not lay the
touch panel down and attach the plasma display to it from above. Service for
damage caused by installation in this way is subject to billing.
Plasma display
Touch panel
(in Vertical Posture)

Protrusion
Mounting screws A
Screw in halfway
Bottom unit
Floor

Mounting
bracket B
INCORRECT
11