Panasonic TY-TP42P10S - Touch-screen - Wired Operating Instructions Manual page 12

Mounting Touch Panel (in Vertical Posture)
Lock the touch panel to the plasma display.
3

Loosen mounting screws A on mounting brackets A and B (temporarily held) and rotate the brackets 90
degrees, as shown in the diagrams, fi t the protrusions located above the round holes on the brackets
into the holes of the top and bottom units. Then tighten both mounting screws A by hand.
Protrusions

Turn the screws on mounting brackets A and B until the gap between the touch panel and plasma
display is closed, then make 2 more full turns to lock in place.
Note
If you are using the touch panel in vertical position, set the sensor position of the touch panel as "Vertical".
(p. 39)
12

Mounting
screws A
Screw
Mounting
bracket A
Top unit
Protrusions
Screw
Mounting
screws A
Mounting
bracket B
Bottom unit
