Flashing Displag Lights - GE PDW9700NII - ProfileTM Dishwasher Owner's Manual

Owners manual
Hide thumbs Also See for PDW9700NII - ProfileTM Dishwasher:
Table of Contents

Advertisement

Available languages

Available languages

ge.com
_
Start
(continued)
D
PDW9000 Series
After selecting the cycle and desired enhancements, touch the START/RESET p ad to ready the
dishwasher to begin the cycle. Closethe door to start the cycle or begin the DELAVSTART countdown.
When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements. If you don't want to change
the settings, simply touch the START/RESET p ad to ready the dishwasher and close the door to begin
the cycle.
Also,if a power failure occurs NORMALand HEATEDDRYwill automatically be programmed. Hake any
new selections and touch the START/RESET p ad to begin the new cgcle.
When the door is opened, the indicator lights will turn off if the START/RESET p ad is not selected within
5 minutes. To activate the displag, open and close the door or touch ang pad.
Clean
PDW8000 Series
The CLEANlight is illuminated when the selected cgcle and enhancements are complete. The light will
stag ON until a pad is pressed or the door is opened and then closed.
PDW9200 Series-PDW9900 Series and CDW9000 Series
The CLEANlight is illuminated and a double beep will sound when the selected cgcle and enhancements
are complete. You mag remove the dishes at ang time. The high-efficiencg fan will run quietly for 30
minutes to 4 hours (depending on selected cgcle) after the CLEANlight is illuminated to continue drying
the dishes.The fan can be turned off bg opening the door and pressing ang kegpad.
ALL MODELS: T o turn off the audible end-of-cgcle signal (or re-activate it if it was previously tumed off),
pressthe HEATEDDRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cgcle
beep option has been toggled.
Flashingdisplay lights.
Status Indicator
Lights
What It Means
START/RESET
Cgcle has been interrupted bg pressing the START/RESET p ad, or there
has been o power failure. Light will stop flashing after the dishwasher
automatically drains out the water. The dishwasher will restart if the
interruption was the result of o power failure.
Recommended dishwasher products.
GErecommends the following products for use in its
dishwashers:
• For your manual detergent dispenser,Cascade®
and ElectrasoF powder, liquid or gel automatic
dishwasher detergents are approved.
• For your SmartDispense
TM
Detergent Dispenser,use
only the recommended detergents listed on page
10 of this manual,
• Jet Dry ®or Cascade Crystal Clear®rinse agents
to remove spots and prevent new film buildup on
your dishes,glasses,flatware, cookware and
plastic. Using rinse agent also improves drg
performance.
• Cascade®Plastic Booster
TM
to remove red staining
inside gour dishwasher that can come from some
tomato-based foods.
• Cerama Brgte ®StainlessSteelAppliance Cleaner
to clean the exterior stainless steel panel of GEand
Profile
TM
dishwashers (for stainless steel exterior
models only).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdw9000 seriesPdw8000 seriesPdw9000 series

Table of Contents