Flashing Displag Lights; Using The Dishwasher - GE GSD4000NBB - Full Console Dishwasher Owner's Manual

Operation of electronic models (model GSD4000 Only)
Using the Dishwasher Door
_The door must be closed and locked into place to select a LOAD SELECTION or an OPTION.
If the door is opened during a cgcle and left open,the dishwasherwill beep once every 30 secondsuntil the
door is cosed and arched into p ace.
Start
Close and latch the doon Touch the
START/RESET
pad to begin the cycle. Water fill begins and
approximately 60 seconds later the wash action begins.
NOTE:The dishwasher remembers your last cycle so you don't have to reprogram each time. When
the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON
and display the last settings you selected.
If gou don't want to change any of the settings, simply touch the START/RESET pad to begin
the cycle.
Also, if a power failure occurs, NORMAL and HEATEDDRY will automatically be programmed.
Make any new selections and touch the START/RESET pad to begin the cycle.
Clean
This light is illuminated when a wash cycle is complete. The light will stag ON until the door is opened.
Flashing Display Lights
Lights What It Means What To Do
This is normal. Allow the dishwasher to drain and reset before you start a new
The START/RESET p ad wash cycle.
has been pressed.
Control Error
CLEAN
Pressthe START/RESET p ad to turn off the beepeEIf the CLEAN
light continues to flash, call for service.
PL US A
BEEPING
SOUND
PLUS A
BEEPING
SOUND
Control Error
Pressthe START/RESET p ad to turn off the beeper and the
dishwasher will attempt to reset. Restart the wash cgde.
If this error continues, turn off the power to the dishwasher at
the circuit breaker for 30 seconds. Trg the dishwasher again.
If the error is still present, call for service.
8