Completing The Fru Replacement - Lenovo 7360D6U - THINKCENTRE M58 7360 Hardware Maintenance Manual

Note: Make sure you note the location and routing of the cables when you disconnect the cables from
the connectors on the system board.
6. Remove the screw that secures the front audio and USB assembly to the chassis.
Figure 66. Removing the securing screw of the front audio and USB assembly
7. Remove the front audio and USB assembly from the chassis.
8. Install a new front audio and USB assembly into the chassis and align the screw hole in the new front
audio and USB assembly with the hole in the chassis.
9. Install the screw to secure the new front audio and USB assembly to the chassis.
10. Connect the new front audio and USB assembly cables to the front audio connector and the front
USB connector on the system board.
11. Reinstall the hard disk drive. See "Replacing the hard disk drive" on page 118.
12. Go to "Completing the FRU replacement" on page 127.

Completing the FRU replacement

After replacing the FRUs, you need to install any removed parts, reinstall the computer cover, and reconnect
any cables, including telephone lines and power cords. Depending on the FRU that was replaced, you
might need to confirm the updated information in the Setup Utility program, see Chapter 6 "Using the
Setup Utility" on page 39.
Note: When the power cord is first plugged in, the computer might appear to turn on for a few seconds and
then turn off. This is a normal sequence to enable the computer to initialize.
To complete the FRUs replacement:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer. See "Locating components" on page 105 for the location of various components.
2. Make sure that the cables are routed correctly before lowering the drive bay assembly.
.
Chapter 9 Replacing FRUs (Machine Types: 3379, 4083, 4088, 4099, 4138, 5897, 6137, 6234, 6258, 6303, 7174, 7220,
7346, 7354, 7357, 7360, 7483, 7582, 7627, 7630, 7638, 8910, and 9964.)
127