Replacing The Microprocessor - Lenovo 7360D6U - THINKCENTRE M58 7360 Hardware Maintenance Manual

Figure 52. Removing the heat sink and fan assembly
5. Place the new heat sink and fan assembly into position and lower the lever to secure the heat sink
and fan assembly.
6. Connect the heat sink and fan assembly cable to the microprocessor fan connector on the system board.
7. Go to "Completing the FRU replacement" on page 127.

Replacing the microprocessor

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait
three to five minutes to let the computer cool before opening the computer cover.
To replace the microprocessor:
1. Open the computer cover. See "Opening the computer cover" on page 103.
2. Pivot the drive bay assembly upward to gain access to the system board. See "Accessing the system
board components and drives" on page 104.
3. Locate the heat sink and fan assembly and disconnect the heat sink and fan assembly cable from the
microprocessor fan connector on the system board. See "Locating parts on the system board" on
page 106.
4. Remove the heat sink and fan assembly. See "Replacing the heat sink and fan assembly" on page 113.
114
ThinkCentre Hardware Maintenance Manual