Operation - Yamaha Sound Edge Manual

Sound Edge Application Software

Operation

This section describes basic operations and provides a tutorial showing how to create an effect
program.
We'll make an effect by using a microphone input sound split into two voices, one an octave
higher (right channel) and one an octave lower (left channel) than the other, and adding an echo
type effect to them. This effect is similar to some effects in VoiceMorph.
First connect a microphone to the MIC jack of the Sound Edge sound card.
1. Select [New] from the [File] menu on the menu bar.
The Type Select dialog box appears.
Select [Type1], then click [OK]. The Type1 block diagram will apply Key Control to the
microphone input sound.
34
Transpose
To make the voices one octave higher and one octave lower from the original voice, you'll
need to modify the Pitch (pitch of the input voice) using Key Shift in the Key Control dialog
box. First you'll need to raise the microphone input level of the 4th and 5th (from the top)
Mixers.
2. Click the 4th (from the top) [Input Mixer]. The Input Mixer setup dialog box appears.
1