Table of Contents
Advertisement
• Up to two PCI or PC cards can be used. However,
you can use only one card at a time.
If you are using an IEEE1394 interface built into the
computer, you can use only one IEEE1394 PCI or
PC interface card.
• When using a laptop or notebook computer, a built-
in IEEE 1394 terminal may not be available. If this is
the case, install an appropriate PC interface card.
Software Installation
For instructions on how to install the software other than one referred to below, see page 28 in the
section "CD-ROM Contents."
mLAN software and OMS
mLAN Tools 2.0 software includes a driver that enables you to connect mLAN devices to a computer.
mLAN Applications for YAMAHA enables audio and MIDI signals to be transferred between a
computer and mLAN devices via mLAN cables. This software enables you to connect the i88X,
mLAN16E, or 01X to a computer via mLAN.
Follow the steps below to install these software applications.
• For explanations on error messages, see page 43.
• For information on the uninstall (removing the installed
application), refer to page 33.
Preparing to install
1
Start the computer.
•When using the mLAN connection, make sure
to disable any energy saving features on the
computer (such as Suspend, Sleep, Standby
or Pause). When using the virtual memory,
turn it off, then restart the computer.
• If you are using the S200 data transfer rate stan-
dard (check the rear panel of your particular
device, or refer to the specifications in the owner's
manual), make sure to uninstall the old version of
mLAN Tools beforehand. (Refer to the owner's
manual of your particular device.)
TOOLS for i88X/mLAN16E, TOOLS for MY16-mLAN, Plug-in Effect
● Plug-in Effect (included only with i88X)
OS
: Mac OS 8.6 through 9.2
Mac OS X 10.2 through 10.3
• When using a PowerBook under battery power,
go Apple menu ➝ [Control Panel] ➝ [Energy
Saver] ➝ [Advanced Settings] (Settings for: Bat-
tery), and remove the check from the "Allow pro-
cessor cycling."
2
Exit from any open applications and close all
open windows.
3
Disconnect all MIDI cables connecting MIDI
devices to the MIDI IN/OUT of the mLAN
device.
4
Using an IEEE1394 (FireWire/iLink) cable,
connect the mLAN device directly to the com-
puter (without use of a hub), and disconnect
all other IEEE1394-connected devices from
the computer.
5
Insert the included CD-ROM ("TOOLS for
i88X/mLAN16E") into the CD-ROM drive.
Installation Guide
31
Advertisement
Table of Contents
