Table of Contents
Advertisement
Connecting a Computer to an mLAN device via mLAN
This section describes the procedure for
connecting a computer to a single mLAN device
peer-to-peer in mLAN Auto Connector.
In mLAN Auto Connector, you can easily
connect an mLAN device by setting up the
wordclock and the number of audio I/O channels.
To connect multiple mLAN devices to a
computer, use mLAN Graphic Patchbay. For more
information on mLAN Graphic Patchbay, refer to
the mLAN Graphic Patchbay Online Manual.
Noise may be generated during the following operations.
Before performing these operations, lower the output
level of each device.
• Turning the power to the computer and mLAN devices
on or off
• Connecting or disconnecting an IEEE1394 (mLAN)
cable
• Making an mLAN connection in mLAN Auto Connector
• Changing the wordclock master and slave status in
mLAN Auto Connector or mLAN Graphic Patchbay
• Selecting On or Off in mLAN Manager (Windows)
• Starting or quitting the OS
• Installing/uninstalling mLAN software
Connecting the i88X
q
w
t
u
i
o
!1
!0
TOOLS for i88X/mLAN16E, TOOLS for MY16-mLAN, Plug-in Effect
• If you use Auto Connector after you make connections
in mLAN Graphic Patchbay, the connections made in
mLAN Graphic Patchbay will be cancelled.
• You can also use mLAN Graphic Patchbay to connect
a computer to a single mLAN device peer-to-peer.
• The mLAN Auto Connector windows may appear dif-
ferent when certain mLAN devices are connected.
1
Connect a computer to an mLAN device using
an IEEE1394 cable.
2
Right-click the YAMAHA mLAN Manager icon
in the Task bar, then select [Auto Connector].
3
Set up the wordclock and specify the number
of audio channels (see below), then click the
[Connect] button. The computer and mLAN
device are connected via mLAN.
!2
e
r
y
Installation Guide
19
Advertisement
Table of Contents
