Starting To Heat - Samsung APH-2807ERX Owner's Instructions Manual

Starting to Heat

You must select the HEAT mode if you wish to adjust the:
Heating temperature
Fan speed when Heating
1 If necessary, press the ON/OFF(
Result: The OPER. light on the indoor unit switches on.
The operation mode previously set is displayed.
The indoor unit beeps twice.
The air conditioner starts up in the current mode.
The air conditioner is fitted with a protection feature which
IMPORTANT
prevents the unit from being damaged when it is started
immediately after being:
Switched on
Stopped
After a rest period of three minutes, it will start up normally.
2 Press MODE under the remote control flap one or more times until the
HEAT indicator is displayed.
3 Select the temperature by pressing the TEMP.SET
or more times until the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Each time you change the temperature by one degree,
NOTE
the indoor unit beeps.
The air conditioner will only start cooling if the room temperature
is higher than the selected temperature.
The fan will, however, operate. During heating, the operating
light is red.
During defrosting, LED may indicate temperature lower
than real one.
4 Select the fan speed by pressing the FAN SPEED button one or more
times until the required setting is displayed:
Low
Medium
High
Auto
Each time you change the fan setting, the indoor unit beeps.
NOTE
For the first 3 to 5 minutes the fan operates very slowly
until the air has been sufficiently warmed.
Once the correct temperature has been reached,
it will be automatically switched to the selected speed.
5 Control the air flow direction when necessary.
Refer to page 16.
) button.
or buttons one
C
11
E-