Rear Panel - Panasonic AJ-BS900 Operation Instructions Manual

Parts and their functions

Rear panel

IN
GEN–
LOCK
RET 1
RET 2
PROMPT
GEN LOCK connectors
These are the standard external signal input connectors
used when locking the camera's synchronization to an
external sync signal.
RET 1 connectors
These are the input connectors for return signal 1, which is
sent to the camera.
RET 2 connectors
These are the input connectors for return signal 2, which is
sent to the camera.
PROMPT connectors
These are the input connectors for the teleprompter signal,
which is sent to the camera.
Triax connector
This is the triax connector used for making connections to
the AJ-CA900P.
COMMUNICATION connector
This connector is used for making connections to an
intercom system. The supports types of intercom system
are 2W, 4W, and RTS. Use the switch on the BS AUDIO
board to select the system. For details, refer to "Switches"
(page 17).
AUDIO CH1 connector
This is the output connection for the camcorder's MIC CH1
signal.
AUDIO CH2 connector
This is the output connection for the camcorder's MIC CH2
signal.
OUT SDI OUT
4:2:2
ENC Y/G
1
4:2:2
ENC PB/B
2
OP1
ENC PR/R
3
OP2
PIX WFM
COMMUNICATION
AUDIO
OUT
PUSH PUSH
CH 1 CH 2
OP3
OP4
WFM
FUSE 400V 15A
AC IN
TALLY
EXT DC IN
SIGNAL
GND
DC 12V IN (external power supply input) jack
This jack is used to connect an external battery for use as a
power supply.
<Note>
Use the AJ-B95 AC adapter (12V, 13A), available as an
optional accessory, for the DC power.
GND terminal
This terminal is used to ground the AJ-BS900P.
Power connector
This connector is used to supply power to the AJ-BS900P.
OP3 connector
This connector is for making connections to an extension
control unit (ECU) or remote control operation panel
(RCOP). The compatible ECU model is the AJ-EC3P.
However, the RCOP cable is required for connection. For
further details, consult your dealer.
OP4 connector
This connector is for making connections to the camera
select unit (CSU) of a master control panel (MCP). The AJ-
BS900P is not compatible with any currently available
CSUs. Plans call for a compatible model to be developed
in future.
WFM control connector
This is an output connection used for waveform monitoring.
One-waveform, two-waveform, and three-waveform control
are supported.
- 7 -
OUT SDI OUT
4:2:2
ENC Y/G
1
4:2:2
ENC PB/B
2
OP1
ENC PR/R
3
OP2
PIX WFM