Control Panel And Keypad - Panasonic MIR-H163-PA Service Manual

INCUBATOR COMPONENTS

Control panel and keypad

3 8 9
5
1 6 7 4 2
1. Power switch (POWER): Power switch of the control panel.
2. Delay timer key (DELAY): This key is to set a delay timer which controls the time from when the
run/stop key (RUN/STOP) is pressed till when the unit starts an operation. Refer to page 14～17.
3. Delay timer lamp (DELAY): This lamp lights while a delay timer is being set.
4. Call key (CALL):
(During stop operation) A set value lamp (SETVALUE) lights and a setting mode is entered by pressing
this key. A temperature and an operation timer can be set (Refer to page 14～17)..
(During operation) A set value lamp (SETVALUE) lights and a set value display mode is entered by
pressing this key. A setting temperature and a setting time of operation timer are displayed (Table 1 on
next page). By re-pressing this key, the set value lamp goes out and the mode returns to normal. In a
set value display mode, a set value cannot be changed.
5. Set value lamp (SETVALUE): In a setting mode or when a set value display mode is entered by
pressing a call key during operation, this lamp lights.
6. Digit shift key ( ): In setting mode, press this key to shift a digit to be set. Also, press this key to
shift a digit to be set from the digital temperature indicator (TEMP) to the digital timer indicator (TIME).
7. Numerical value shift key ( ): Press this key to shift a numerical value in setting mode.
8. Digital temperature indicator (TEMP): Refer to Table 1 on next page.
9. Digital timer indicator (TIME): Refer to Table 1 on next page.
10
-30-