Panasonic AJ-BS900 Operation Instructions Manual page 5

Parts and their functions
Front panel
Intercom XLR connector
This is used to connect a headset to the intercom.
PGM level knob
This knob is used to adjust the volume of the PGM audio
mixed into the signal fed to the intercom headset.
SYSTEM/PRIVATE selector switch
This is used to toggle the intercom between the system and
private modes.
SYSTEM: The intercom is connected to the system via the
communication connector on the rear panel of
the unit.
PRIVATE: The intercom is not connected to the system via
the communication connector on the rear panel
of the unit.
INTERCOM level knob
This knob is used to adjust the volume of the microphone
input to the intercom.
MIC button
This button is used to switch the intercom microphone on and off. It has three positions: ON, OFF, and PTT. (PTT: Audio
transmission continues as long as the button is held down.)
Phase adjustment switch
The available settings are SC PHASE, OFF, and H PHASE.
SC PHASE: Selects SC phase adjustment.
OFF: No phase adjustment is performed.
H PHASE: Selects H phase adjustment.
Phase adjustment buttons
These buttons are used to adjust the phase selected using the phase adjustment switch
GEN LOCK indicator
This indicator lights when the camera's synchronization is locked using the signal input via the GEN LOCK connectors on the
rear panel.
<Note>
This indicator blinks if there is something wrong with the GEN LOCK signal. When this happens check the GENLOCK signals.
RIAX
ON
OFF
- 4 -
VTR
ENABLE REW
GENLOCK
ON
SC OFF H
PHASE PHASE
OFF
SET UP
INTERCOM
MIC
(PUSH)
ON
OFF
PTT
MON SEL
PGM
SYSTEM
B SUP
G
R
PRIVATE
KNEE
POINT
PUSH
KNEE
SLOPE
.