Advertisement
INCUBATOR COMPONENTS
LCD touch panel
The following display (called the Top screen) will appear when the power switch is turned ON.
Note: It takes approximately 20 seconds until Top screen is displayed. During warming-up, "Status: Gas
sensor initializing" is displayed in the Message display field (13), and "--.-" is displayed in the Present CO
density display field (4).
3
1
1. Present temperature display field
The current chamber temperature is displayed.
2. Set temperature value display field
The set value of chamber temperature is
displayed. Default setting: 37
3. Heating indicator
This lamp lights when the heater is energized.
4. Present CO
density display field
2
The current chamber CO
Nothing is displayed when CO
5. Set CO
density value display field
2
The set value of the chamber CO
displayed. Default setting: 0 %.
*1: Only when an optional component MCO-21GC (Gas auto charger) is installed, this key is workable. They
are not displayed when the MCO-21GC is not installed.
12
2
o
C.
density is displayed.
2
density is set 0 %.
2
density is
2
6
7
6. CO
gas injection indicator
2
This lamp lights when CO
injected.
7. CO
gas supply line indicator A and B*
2
Current supplying CO
2
(connecting port for CO
displayed. The connecting port A/B for gas
pipe that is currently supplying CO
displayed in reverse video and blinks.
8. CO
gas supply line select key*
2
This is a key to select CO
or B (Connecting port A or B for CO
pipe). When an optional gas auto charger
MCO-21GC is installed, CO
A/B changes over automatically when CO
gas cylinder is empty. Changeover is also
workable by pressing this key.
2
8
5
4
gas is being
2
1
gas supply line
gas pipe) is
2
is
2
1
gas supply line A
2
gas
2
gas supply line
2
2
Hide quick links:
Advertisement
