Download  Print this page

System Connection - Kenwood KTF-2010 Instruction Manual

Fm/mw/lw tuner
Hide thumbs

Advertisement

System connection

Connection of the Audio components/Connection of the system control cord
4
Make connections as shown below.
When connecting the related system components, refer also
to the instruction manuals of the related components.
Do not plug in the power lead until all connections are com-
pleted.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the
unit (from the largest outer dimensions including projections) equal
to, or greater than, shown below.
Left and right panels: 10 cm
Rear panel: 10 cm
KTF-3010 only
The system control connection
Connecting system control cords after connecting a Kenwood audio component system lets you take advantage of convenient system
control operations.
There are two Kenwood system control modes. Make connections according to the groups of terminal symbols shown below.
[SL16] Mode : for
[XS8] Mode : lets you combine F, f, and ƒ terminals
This unit is compatible with both [SL16] and [XS8] modes. It comes from the factory set to the [SL16] mode. To switch to the [XS8] mode,
follow the instructions in "Switching from [SL16] to [XS8]".
1. [SL16] equipment cannot be combined with [XR], [XS], and [XS8] equipment for system
operations. If your equipment consists of this kind of combination, please do not connect
Notes
Notes
any system control cords. Even without system control cords, normal operations can be
carried out without affecting performance.
2. If your amp or receiver does not have a system control terminal, do not connect any
system control cords to the system control terminals on the other components.
3. Do not connect system control cords to any components other than those specified by
Kenwood. It may cause a malfunction and damage your equipment.
4. Be sure the system control plugs are inserted all the way in to the system control termi-
nals.
1.Connect all cords firmly. If connections are loose, you may lose the sound or interconnectable system control operations may not work.
2.When plugging and unplugging connection cord, be sure to first remove the power cord from the AC outlet. Plugging / unplugging
Notes
Notes
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Audio cord
OUTPUT
ANTENNA
FM
75
GND
AM
L
R
A
B
terminals only
Malfunction of microcomputer
If operation is not possible or erroneous display ap-
pears even though all connections have been made
properly, rest the microcomputer referring to "In case
of difficulty".
TUNER
Pre-main amplifier
L
STEREO INTEGRATED AMPLIFIER
KAF-3010R
R
CD
PHONO
TUNER
ON/STANDBY
POWER
ON
OFF
PHONES
A
SPEAKER
B
BASS
TREBLE
BALANCE
|
{
|
{
L
R
SYSTEM
CONTROL
ƒ
SL16 XS 8
No matter to which of the two terminals the con-
nection is made, the use method is the same.
KTF-3010/KTF-2010 (En)
SYSTEM CONTROL
ƒ
SL16 XS 8
VOLUME CONTROL
SOURCE DIRECT
TAPE
MD
MIN
MAX
INPUT SELECTOR
MUTING
LOUDNESS
T R A I T
thermally reactive advanced instantaneous transistor
System control cord
^
To wall AC
outlet

Advertisement

loading

  Related Manuals for Kenwood KTF-2010

This manual is also suitable for:

Ktf-3010