Kenwood KTF-2010 Instruction Manual page 12

Displaying broadcast station names
12
Preparation
Switch the ON/STANDBY key to ON.
Entering broadcast station names
1
Call up (select) the preset station.
Follow the steps in "Receiving a preset station" to call up
stored stations with no PS display, MW stations and LW sta-
tions.
2
Select the Entry mode.
Press the 0/CHARA. key
7
3
Enter the characters.
1 Select the characters and symbols using
the TUNING/MULTI CONTROL knob.
2 Press the 0/CHARA. key to confirm the
characters. The cursor will move to allow
the next entry.
3 Repeat steps 1 and 2.
4 Press the MEMORY key to confirm entry.
!
8 9
0/CHARA.
TUNING/MULTI CONTROL
DOWN UP
7 8 9 0/CHARA.
MEMORY
The figure shows an example for the KTF-3010
AM-FM STEREO SYNTHESIZER TUNER KTF-3010 HIGHBLEND
WIDE
NARROW
ACTIVE
RECEPTION IF BAND RF ATT ANT A/B
RFATT
PTY/
MEMORY
TA/NEWS PTY SCARCH DISPLAY
ON/STANDBY
1 2
: Keys or controls to be used in this operation.
STANDBY
AR
) 8
AM
FM
[ ............................................................................................................................ ]
AR
1
AM
-
FM
÷ The entry mode will be cancelled unless the next steps are completed
within 10 seconds.
÷ The station name cannot be entered if "PS" is displayed.
[ ............................................................................................................................ ]
You can select from the following characters and symbols.
A,B,C.....X,Y,Z,0,1,2,3
The selected characters will blink.
STANDBY AR
A 1 + B
AM
FM
÷ To correct the characters, before pressing the MEMORY key, press
the 0/CHARA. key several times to make the character that needs
correcting flash, then re-enter the character.
÷ If only spaces are entered, a station name will not be stored.
÷ To delete all entered characters, press the +10/CLEAR key in the
entry mode.
÷ If you press the DISPLAY key after entering the name of the broadcast
station, the entered station name and frequency will be displayed in
turn. (if none has been entered "NO TITLE" will appear).
KTF-3010/KTF-2010 (En)
TUNING/MULTI CONTROL
BAND
TUNING MODE +10/CLEAR
P. CALL
DOWN
3 4 5 6 7 8 9 0/CHARA.
ANT A B STEREO
TUNED
8 9 ) )
AUTO
kHz
MHz
ANT A B B STEREO
TUNED
8 9 0 0 ;
AUTO
kHz
MHz
-
. + /
....8,9, , , ,
* ,
Space
MEMO ANT A B STEREO
TUNED
2 ; 0 0
AUTO
-
kHz
Enter up to 8 characters.
UP