Kenwood KTF-2010 Instruction Manual page 11

Receiving a preset station
Receiving a preset station
1
Set to the Call up (Sellect) mode.
2
Select one of the preset numbers.
TUNING/MULTI CONTROL
DOWN
When you stop turning the knob, you tune in on the preset
station.
Instead of steps 1 and 2, you can use the numeric keys
(0~9,+10), to store the broadcast stations.
Press the numeric keys (0 to 9, +10) in the
following order.
To select "15"...0,5
To select "20"...0,0, )
Memory back up
Even if the power cord is unplugged from the AC outlet, the
preset memory contents will be backed up for 3 days.
P. CALL
UP
The figure shows an example for the KTF-3010
AM-FM STEREO SYNTHESIZER TUNER KTF-3010 HIGHBLEND
WIDE
NARROW
ACTIVE
RECEPTION IF BAND RF ATT ANT A/B
RFATT
PTY/
MEMORY
TA/NEWS PTY SCARCH DISPLAY
ON/STANDBY
1 2
: Keys or controls to be used in this operation.
STANDBY
AR
P C L 5
AM
FM
÷ Press P.CALL key once more to cancel the call up mode and return to
the original display.
[ ............................................................................................................................ ]
Blinks for 5 sec.
STANDBY
AR
2 6
AM
FM
÷ While the display is blinking, you can select the next station.
÷ If the tuner has stored a preset station name or program service name,
each will be displayed.
÷ You cannot enter numbers over 40.
÷ If you make a mistake when pressing the 0 key, press the 0
key several times to return to the original display before re-entering.
Last channel memory
When the power is turned ON or the BAND key is pressed to
switch the band, the last station previously received is auto-
matically tuned in.
KTF-3010/KTF-2010 (En)
TUNING/MULTI CONTROL
BAND
TUNING MODE +10/CLEAR
P. CALL
DOWN
3 4 5 6 7 8 9 0/CHARA.
MEMO ANT A B STEREO
TUNED
A L 0
AUTO
kHz
ANT A B STEREO
TUNED
.
9 ) ) )
AUTO
kHz
MHz
11
UP