System Connections - Kenwood KT-5020 Instruction Manual

Make connections as shown in the diagram below.
Do not plug the power cord into the wall outlet until all connections have been completed.
FM indoor
antenna
FM outdoor
antenna
AM outdoor antenna
Afeeder (FD-MD
V-[Y!-'
75 ohm/300 ohm
antenna adaptor
When this unit is combined with an amplifier
having KENWOOD SYSTEM CONTROL termi¬
nals. system operations such as remote control
as a system is made possible. For details, refer
to the instruction manual of the amplifier.
If your amplifier or receiver is not equipped
with the SYSTEM CONTROL terminals, do not
connect anything to any SYSTEM CONTROL
terminals.
Do not connect the unit in any system config¬
uration other than specified.
Adjust the direction
of the loop antenna
so that reception is
optimized.
Notes:-—-
1. Be sure that all the connecting cords are connected properly.
If they are not, the sound may not be produced or there may
be noise interference.
2. When taking out and putting in the connecting cords, be sure
to turn the power of this unit OFF and turn the amplifier's
volume to minimum, if this is not done, it can lead to errors in
functioning.
■ System operation
© System operation via system control connection with
an amplifier.
The SYSTEM CONTROL jacks on KENWOOD amplifiers
are marked with either " 0<n " or " DO".
By connecting the SYSTEM CONTROL jack of this unit
with that of a KENWOOD amplifier, the following system
operations are possible.
When connected to an " OGO " jack: This unit can be
controlled as part of the entire system with the remote
control unit provided with the amplifier.
When connected to an " DO " jack: This unit can be
controlled as part of the entire system with the remote
control unit provided with the amplifier for easy operation.
For details, refer to the instruction manual provided with
your amplifier.
■ AM loop antenna setting
Insert the supplied AM loop indoor antenna into the
supplied loop antenna stand.
Place the stand on a stable surface, for example on a shelf,
or install it on a rack or wall with wood screws.
Note: ---
Place the AM loop indoor antenna as apart as possible from the
TV, speaker cords, power cords and system control cords.
■ AM outdoor antenna
In steel buildings or at a great distance from the transmit¬
ter, it may be necessary to install an outside longwire
antenna. The end of this wire should be stripped of
insulation and connected to the AM terminal. At this time,
keep the loop antenna connected.
6
KT-5020 (En>