Recording; Recording Audio (Analog Sources) - Kenwood KRF-V7050D Instruction Manual

20
Muting the sound
The MUTE key lets you mute the sound of the speakers.
Press the MUTE key.
SP A B TI.VOL
CLIP MUTE
RDS EON PTY
TP TA NEWS
Blinks
To cancel
Press the MUTE key again so that the "MUTE" indicator goes off.
• MUTE ON can also be deactivated by turning the volume control
knob.
SOURCE DIRECT playback (for analog input sources only)
Use this function to pass the source material direct to the amplifier,
bypassing any audio processing.
Press the SOURCE DIRECT key.
FM AUTO SOUND DIGITAL
AM PRO LOGIC S.DIRECT
MHz 3 STEREO MONITOR
kHz DOWN MIX DSP
• When you press the LISTEN MODE, SOUND, or SET UP keys,
or switch to another input source, SOURCE DIRECT playback will
be canceled.
• If CINEMA EQ. is switched ON, SOURCE DIRECT key will not be
effective.
• If SOURCE DIRECT is switched ON, CINEMA EQ. function will not
be effective.
To cancel
Press the SOURCE DIRECT key again.
• If SOURCE DIRECT playback was activated while in a surround
mode, canceling SOURCE DIRECT playback will reactivate the pre-
vious surround mode.
Listening with headphones
1 Press the SPEAKERS A or B key so that the speaker indica-
tor goes off.
Make sure the SPEAKERS
indicators are turned off.
SP
CLIP
RDS EON
TP
• If you turn off all of the speakers when in the surround mode, the
surround mode will be canceled as well, resulting in stereo playback.
2 Connect the headphones to the PHONES jack.
PHONES
3 Use the VOLUME CONTROL knob or VOLUME keys to adjust
the volume.
Normal playback
L C R
LFE SW
LS S RS
AUTO
MEMO
ST.
TUNED
A B TI.VOL
L C R
MUTE
LFE SW
PTY
LS S RS
TA NEWS

Recording

Recording audio (analog sources)

Recording a music source
1 Use the INPUT SELECTOR knob to select the source (other than
"MD/TAPE") you want to record.
2 Set the cassette deck or MD recorder to record.
3 Start playback, then start recording.
Recording tapes or MD (with MONITOR function)
MONITOR = MD/TAPE recording
1 Press the MONITOR key.
2 Use the INPUT SELECTOR knob to select a source other than
"MD/TAPE"
3 Start playback on the cassette deck connected to the MONITOR
jacks and start recording on the cassette deck or MD recorder
connected to the MD/TAPE jacks.
MD/TAPE = MONITOR recording
1 Use the INPUT SELECTOR knob to select "MD/TAPE".
2 Start playback on the cassette deck connected to the MD/
TAPE jacks and start recording on the cassette deck or MD
recorder connected to the MONITOR jacks.
• To copy tapes using a double cassette deck, refer to the instruction
manual of the double cassette deck.
MONITOR function (analog sources only)
You can connect a cassette deck or graphic equalizer to the MONITOR
jacks of the receiver. If a graphic equalizer is connected, the MONITOR
key should be left in the on position. Alternately, if a cassette deck
equipped with a 3-head system is connected to the MONITOR jacks,
you will be able to monitor the just-recorded signal while making
recordings on the cassette deck. By switching the MONITOR key on
and off, you can compare the sound of the source signal and the just-
recorded signal. For more information, refer to the instruction manual of
the connected component.
MONITOR
INPUT SELECTOR
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
MHz 3 STEREO MONITOR
kHz DOWN MIX DSP TUNED
Continued to next page
ST.