Rds Auto Memory; Presetting Radio Stations Manually - Kenwood KRF-V6200D Instruction Manual

RDS Auto Memory

This function automatically stores up to 40 RDS stations in the
preset memory. In order to use the PTY function, the RDS stations
must be stored in the preset memory using the RDS AUTO
MEMORY function.
BAND
TUNER
AUTO MEMORY
œ Use [TUNER] to select the tuner.
∑ Use [BAND] to set the broadcast band to "FM".
é Press [AUTO MEMORY].
• After a few minutes, up to 40 RDS stations are preset in order from
channel "01".
• Stations already stored in the preset memory may be replaced by
RDS stations. (i.e., If the RDS AUTO MEMORY function detects 15
RDS stations, the stations currently preset at numbers 01–15 will
be replaced by the RDS stations.)
Presetting radio stations
manually
The RDS auto memory function assigns preset numbers to RDS
stations starting from preset number "1". Therefore, be sure
to execute the RDS auto memory function before using the
following operations to manually store AM stations and other FM
stations, and RDS stations.
See <RDS Auto Memory>.
MEMORY
œ Tune to the station you want to store.
∑ Press [MEMORY] while receiving the station.
Proceed to step é within 20 seconds.
(If more than 20 seconds elapse, press [MEMORY] again.)
é Use [MULTI CONTROL 5/∞] to select one of the
station presets (1 – 40).
® Press [MEMORY] again to confirm the setting.
• Repeat steps œ, ∑, é, and ® to store as many stations as
necessary.
• If you store a station at a previously used preset, the previous
station will be replaced by the new one.
MULTI CONTROL
/
English
33