Before applying power
Caution : Read this page carefully to ensure safe
Units are designed for operation as follows.
Australia ......................................................................................AC 240 V only
Europe .........................................................................................AC 230 V only
Information on Disposal of Old Electrical
and Electronic Equipment (applicable for EU
countries that have adopted separate waste
Products with the symbol (crossed-out
wheeled bin) cannot be disposed as
Old electrical and electronic equipment
should be recycled at a facility capable of handling
these items and their waste by products.
Contact your local authority for details in locating a
recycle facility nearest to you.
Proper recycling and waste disposal will help conserve
resources whilst preventing detrimental effects on our
health and the environment.
TO PREVENT FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR
RISK OF ELECTRIC SHOCK
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL,
WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF UNINSULATED
"DANGEROUS VOLTAGE" WITHIN THE PRODUCT'
S E N C LO S U R E T H AT MAY B E O F S U F F I C I E N T
MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC
SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL
TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND
MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.
DO NOT OPEN
Unpack the unit carefully and make sure that all the accessories
FM indoor antenna (1)
Remote control unit (1)
If any accessories are missing, or if the unit is damaged or fails to
operate, notify your dealer immediately. If the unit was shipped
to you directly, notify your shipper immediately. Kenwood
recommends that you retain the original carton and packing
materials in case you need to move or ship the unit in the future.
Keep this manual handy for future reference.
Notes on instructions
The operating instructions given in this manual assume that the
user mainly operates the receiver using the remote control unit.
When the same operation is also available on the main unit, the
operating method is indicated in illustrations.
The [VOLUME CONTROL], [MULTI CONTROL] and [INPUT
SELECTOR] knobs on the main unit are operated by turning the
knobs clockwise or counterclockwise.
Getting into the setup mode
The setup procedure is identical for all of the setting elements.
Once you remember the following procedure, you can easily set
up other setting elements.
œ Press [SETUP] to enter the setup mode.
∑ Use [MULTI CONTROL 5/∞] to select the element to
Low frequency effects level
Exit the setup mode.
é Press [SETUP] to get into the setup mode of the
AM loop antenna (1)
Batteries (R03) (2)
The knob on the main unit
is pointed with an arrow to
indicate that it can be turned in
procedures refer to
those of the remote
control unit. Some
operations are also
available using the key
(or knob) of the same
name on the main unit.
Options to be
selected are listed
in a table.