Kenwood VZ-5000 Instruction Manual page 18

Installation
Connection
2WARNING
If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in
turn may start a fire. Always connect those wires to the power source running through the fuse box.
When detaching the conneection cable, use the accessory tool
(Accessory- F) as show in the diagram.
Ignition key switch
C
+
Battery
Parking sensor cable (Green)
To parking brake detection switch harness of car
For the sake of safety, be sure to connect the
parking sensor.
18 English
Remove the protective sheet on the
connector before the KTC-V500N/
KTC-V500P is connected.
ACC
A
B
2CAUTION
• Do not leave this unit in any position where the FM transmitter
antenna is bent or blocked off by metal parts.
• Extend the FM transmitter antenna toward the FM receiving
antenna for optimal reception.
A
B
C
Navigation Unit
Connection cable
(Provided with the KENWOOD
Navigation Unit)
FM transmitter antenna (White)
FM-TX
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
KTC-V500N/KTC-V500P (Optional)
UNIT MONITOR TO
Connection cable
(Provided with the KTC-V500N/KTC-V500P)
Monitor Unit (Rear side)
ANTENNA
L
FM/AM
( 5A )
Accessory A
INPUT ANTENNA TV