Setting Of The Switching Mode Of Input Video Signal Types; Ending The Video Setting Screen; Ending The Clock Adjustment Screen - Kenwood VZ-7000N Instruction Manual

Video Setting Screen (VZ-7000P only)
V D 1 M O D E
A U T O N T S C
V D 2 M O D E
A U T O N T S C
V I D E O
Setting of the switching mode of input
video signal types
This function switches between the automatic
detection and the fixed detection for input signal
types of VIDEO1 and VIDEO2.
VD1 MODE
[7AUTO] : Setting of the automatic detection mode
[7NTSC] : Setting of the NTSC fixed mode
[7PAL] : Setting of the PAL fixed mode
VD2 MODE
[7AUTO] : Setting of the automatic detection mode
[7NTSC] : Setting of the NTSC fixed mode
[7PAL] : Setting of the PAL fixed mode
NOTE
It may take time to enable the automatic detection
when "AUTO" is set.

Ending the Video Setting Screen

Touch [ RTN ] to return to the setup menu screen.
Clock Adjustment Screen
C L O C K
P A L
P A L
C L O
RTN
Adjusting the Time
If the Center unit is not connected, you can set the
clock time.
Touch [ 5 ] to advance
the hours.
Touch [ ∞ ] to make the
hours go back.
Setting the Minutes to "00":
Touch [ RESET ] to set the minutes to "00".
NOTE
Touch [ RESET ] while the minute is below "30"
rounds it off, and while the minute is "30" or more
rounds it up.

Ending the Clock Adjustment Screen

Touch [ RTN ] to return to the setup menu screen.
1 2 : 0 0 P M
C K A D J U S T
[CLOCK]
Touch [ 5 ] to advance
the minutes.
C L O C K
1 2 : 0 0
Touch [ ∞ ] to make the
minutes go back .
R E S E T
RTN
11