Touch Sensor Tone; Manual Time Adjustment; Automatic Time Adjustment; Selectable Illumination - Kenwood KRC-689 Instruction Manual

Menu settings

Touch Sensor Tone

This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Display and setting:
"Beep ON" : Beep setting is on. (Default setting)
"Beep OFF" : Beep setting is off.
NOTE
The beep sound is not output from the preout jacks.

Manual Time Adjustment

Adjust the time manually.
NOTE
This adjustment is available only when the automatic time
adjustment is set to off. (page 28)
Display and setting:
1
Select the display "Clock Adjust" during the selecting function
in the menu system.
Press either the 4 or ¢ button for at least one second to
2
enter the Manual time adjustment mode.
The time display will blink.
3
• Adjusting the hours
Press the FM button to advance the hours, or press the AM
button to make the hours go back.
• Adjusting the minutes
Press the ¢ button to advance the minutes, or press the
4 button to make the minutes go back.
4
Press the MENU button to end the Manual Time Adjustment
mode.
Exiting the Manual Time Adjustment mode would start the
clock counting.

Automatic Time Adjustment

With automatic time adjustment, you can set the clock time
automatically according to time data sent from RDS stations
(after receiving RDS signals for several minutes). You can also
set the time manually if the automatic time adjustment
function is turned off.
Display and setting:
"SYNC ON" : Automatic Time Adjustment (Default setting)
"SYNC OFF" : Manual time adjustment
Adjusting Time Automatically:
Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
NOTE
The time is not adjusted when the RDS station you are tuned to
is not transmitting a time signal. Choose another RDS station in
such a case.

Selectable Illumination

You can switch the color of the button illumination between
green and red.
Display and setting:
"Button Green" : The color of the illumination is green.
"Button Red" : The color of the illumination is red.

Switching Graphic Display

This function allows you to turn off the lower part of the
display if there is too much information in the display.
Display and setting:
"Graphic ON" : The display will turn on by using the whole part
of the display. (Default setting)
"Graphic OFF" : The display will turn on by using only the upper
part of the display and the IN indicator.
— 28 —
Function of the KRC-781R
Function of the KRC-781R/KRC-789