Kenwood KRC-689 Instruction Manual page 38

Installation
■
Removing the hard rubber frame
1
Refer to the section "Theft deterrent faceplate (P. 8)" and
then remove the faceplate.
2
Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Push upward the frame and pull it forward as shown in the
figure.
Accessory3
Removal tool
3
When the upper level is removed, remove the lower two
locations.
NOTE
The frame can be removed from the bottom side in the same
manner.
Lock
Catch
— 38 —
■
Removing the Unit
1
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
2
Remove the Hex-head screw with integral washer (M4×8) on
the back panel.
3
Insert the two removal tools deeply into the slots on each
side, as shown.
Accessory6
Accessory3
Removal tool
4
Push upward the removal
tool toward the top, and
pull out the unit halfway
whilst pressing towards the
inside.
2CAUTION
Be careful to avoid injury from the catch pins on the removal
tool.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
Catch facing up