Disc Name Preset Play (Dnpp) - Kenwood KRC-689 Instruction Manual

"NAME SET" is displayed and the disc name preset mode is
entered. The cursor blinks in the position where character
input can be made.
Press either the 4 or ¢ button to move the cursor to the
3
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
Each time the 38 button is pressed, the characters to be
4
entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z (KDC-__ Only)
Numerals and symbols: 0~9 @ " ' ` % &
Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä ê
ë î ï ô ö û ü ñ ç © Æ › fi
5
Continue steps 3 and 4 until all the characters are chosen for
the name.
6
Press the NAME.S button.
The disc name is stored and the disc name preset mode is
canceled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
NOTE
• The number of characters and discs whose names can be
stored will differ depending on the disc changer that is
connected. Please see your disc changer manual for details.
• Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
• Pressing the reset button does not erase the disc names stored
in a disc changer.

Disc Name Preset Play (DNPP)

If you have preset the name of a disc that you want to listen to
in the disc changer, you can look for it by name and start
playing it.
1
Press the DNPP button on the remote.
"DNPP" will appear in the display, and the disc name preset
play mode is entered.
The preset names/disc titles of the disc in the disc changer to
which you are currently listening are successively displayed for
five seconds each. In any of the units that are connected, discs
that have not been disc name preset will display "NO NAME".
NOTE
∗ + - = , . / \ < > [ ]
• This function can only be used in disc changers that were
manufactured or sold as of 1997. Also note that some units
cannot provide a display unless the disc name preset has been
made by the unit that is playing.
• Discs in the disc changer that have never been played before
will appear as "NO ACCESS" when the disc names are
displayed. When you cannot identify a disc because of the "NO
ACCESS" display after inserting a disc magazine, try playing it to
display the disc name. Also note that "NO DISC" will be
displayed when a disc has not been loaded.
Rapid display (forward / reverse):
Press the DISC
Pressing the DISC
names/disc titles in order.
Pressing the DISC
names/disc titles in reverse order.
2
When the name appears for the disc you want to play
Press the OK button.
The disc whose name is displayed will be recalled, and the disc
name preset play (DNPP) mode will end.
To cancel DNPP mode:
Press the DNPP button.
The disc name preset play (DNPP) mode will be canceled.
— 25 —
(Function of Remote)
+
–
or DISC button.
+
button will rapidly display the preset
–
button will rapidly display the preset