Connecting Wires To Terminals - Kenwood KDC-139 Instruction Manual

Connecting Wires to Terminals

To Kenwood disc changer/
External optional accessory
(KDC-MP439 only)
Fuse (10A)
Wiring harness
(Accessory1)
Power control/Motor antenna control wire
(Blue/White)
TEL mute wire (Brown)
Not Used (Blue)
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
16
|
KDC-MP439/KDC-MP3039/KDC-MP339/KDC-MP239/KDC-139
Rear preput/ Subwoofer preput
FM/AM antenna input
If no connections are made, do not let the wire come out from the tab.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Front preput(KDC-MP439 only)
Connect either to the power control terminal
when using the optional power amplifier, or to
P.CONT
the antenna control terminal in the vehicle.
Connect to the terminal that is grounded
when either the telephone rings or during
MUTE
conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
⁄
ANT.
Do not let the wire come out from the tab.
CONT
Ignition key switch
Car fuse box
ACC
Car fuse box
(Main fuse)
+
–
Battery