General Operation; Audio Control; Audio Setup; Speaker Setting - Kenwood KDC-139 Instruction Manual

General Operation

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
Adjustment Item Display
Subwoofer level "SW L"/ "L SUB"
System Q "NATURAL/FLAT"/
"ROCK"/ "POPS"/
"EASY"/ "TOP40/TP40"/
"JAZZ"/ "USER"
Bass level "BAS L"/ "L BAS"
Middle level "MID L"/ "L MID"
Treble level "TRE L"/ "L TRE"
Balance "BAL"/ "BL"
Fader "FAD"/ "FD"
Exit Audio Control mode (Volume control mode)
⁄
• "USER": This appears when Bass level, Middle level, and
Treble level are adjusted. When "USER" is selected,
these levels are recalled.
4
Adjust the Audio item
Turn the [VOL] knob.
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob.

Audio Setup

Setting the Sound system.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Adjustment Item Display
Low Pass Filter "LPF"
Volume offset "V-OFF"/ "V-OF" –8 — ±0 (AUX: -8 — +8)
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
6
|
KDC-MP439/KDC-MP3039/KDC-MP339/KDC-MP239/KDC-139
Range
–15 — +15
Natural/Rock/Pops/Easy/
Top 40/Jazz/User setting
–8 — +8
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
Range
80/120/160/Through(OFF) Hz
4
Adjust the Audio setup item
Turn the [VOL] knob.
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY"/ "STBy" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Speaker type
OFF
For 5 & 4 in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
4
Exit Speaker Setting mode
Press the [VOL] knob.
Function of KDC-MP439/KDC-MP3039/KDC-MP339/
KDC-MP239

Switching Display

Changing the information displayed.
1
Enter Switching Display mode
Press the center of the Control knob for at least
1 second.
"DISP SEL" is displayed.
2
Select the Display item
Press the right or left side of the Control knob.
In Tuner source
Information
Frequency
Clock
Display
"SP OFF"/ "SP-F"
"SP 5/4"/ "SP-5"
"SP 6*9/6"/ "SP-6"
"SP OEM"/ "SP-O"
Display
"FREQ"
"CLOCK"