Disabled System Indicator (Dsi) - Kenwood KDC-1018 Instruction Manual

in its special storage case while detached.
• Do not expose the faceplate or its storage case to direct
sunlight or excessive heat or humidity. Also avoid places with
too much dust or the possibility of water splashing.
Reattaching the Faceplate:
1
Align the projections on the unit with the grooves on the
faceplate.
2
Push the faceplate in until it clicks.
The faceplate is locked in place, allowing you to use the unit.

Disabled System Indicator (DSI)

A red indicator will blink on the unit after the faceplate is
removed, warning potential thieves. The factory default for
this function is ON.
Turning Disabled System Indicator On/Off:
1
Turn the power of the unit off.
2
While pressing buttons #1 and #3 at the same time, press the
SRC button.
Repeat steps 1 and 2 above to turn DSI back on.
NOTE
The KDC-4018/4018G has the equivalent function.
For details, refer to the Disabled System Indicator page for the
menu settings.(page 20)
Operation of the KDC-2018
— 11 —
Tuner features
#1-6
KDC-4018/4018G
Band display
Preset station number
AUTO indicator
ST indicator
KDC-2018
ST indicator
Preset station number
Band display
KDC-1018
Preset station number
Band display
ST indicator
4/¢
CRSC
SRC CLK/
AUTO/
MENU
AME
Frequency
CRSC indicator
AUTO indicator
Frequency
CRSC indicator
AUTO indicator
Frequency
FM/
AM