Station Name Preset (Snps); Frequency Step Setting - Kenwood KDC-1018 Instruction Manual

Recalling a Preset Station:
Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.
Function of the KDC-4018/KDC-4018G

Station Name Preset (SNPS)

You can assign names to radio stations with the Station Preset
Memory. Up to 18 FM stations and 16 AM stations can be
assigned names.
1
Adjust the frequency to the station whose name you want to
enter.
2
Enter the menu mode
Press the MENU button for at least one second. "MENU" is
displayed when the menu mode is entered.
3
Press the FM or AM button to select the display "NAME SET" .
Press either the 4 or ¢ button for at least two seconds to
4
enter the station name preset mode.
The cursor will blink in the position where letters are entered.
Press either the 4 or ¢ button to move the cursor to the
5
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
6
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
Alphabet : A ~ Z
Numerals and symbols : 0~9 @ " ' ` % & * + - = , . / \ < > [ ]
7
Continue steps 5 and 6 until all the characters are chosen for
the name.
NOTE
You can enter up to eight characters for each name.
8
Assigning Names
Press the MENU button.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.
NOTE
• You can assign names to up to 18 FM stations and 16 AM
stations.
• All the station names will be erased if you press the Reset
button.
• If you want to change the name of a station, first display the
name of the station (following steps 1 to 4 above), then change
the letter(s) that you want by following steps 5 and 6.

Frequency Step Setting

Switch the frequency step used in seeks. The factory defaults
are 50 kHz for FM and 9 kHz for AM.
1
Turn the power off.
2
Hold down buttons #1 and #5, then turn the power back on.
The frequency step settings will be changed to 200 kHz for FM
and 10 kHz for AM.
NOTE
When you change the frequency step settings, all memory
contents will be erased.
Returning Frequency Step Settings to Original Values:
Repeat steps 1 and 2 above.
— 13 —