Table of Contents
Advertisement
Web Configuration Interface
IP Configuration
The IP Configuration page (FIG. 33) allows you to specify how the Web Configuration Interface
acquires an IP address. You can enable or disable DHCP address acquisition or you can assign a fixed IP
address to the interface.
FIG. 33
IP Configuration page
IP Configuration
DHCP Address
DHCP Gateway
DHCP Mask
DHCP DNS Server
DHCP
Static IP Address
Static IP Gateway
Static IP Mask
Setting DHCP Configuration
The current DHCP status is displayed along with the DHCP address, gateway, mask and DNS server that
has been acquired.
To enable or disable DHCP address acquisition:
1. From the IP Configuration page, select whether to Enable or Disable DHCP.
2. Click the Save Settings button. If the new parameters are acceptable, the new screen will read
"Restarting. Please Wait..." before moving to the Summary page.
3. Click the IP Configuration link at the top of the Summary page to confirm that the DHCP
configuration values were changed.
All changes will take effect after the PTE-300 reboots.
34
The current DHCP address.
The current DHCP gateway address.
The current DHCP mask address.
The current DHCP DNS server address.
This selects whether DHCP is enabled or disabled, in order to allow static IP.
The current static IP address.
The current static IP gateway address.
The current static IP mask address.
PTE-300 PosiTrack Ethernet Camera Controller
Advertisement
Table of Contents
