Table of Contents
Advertisement
Installation
Connections and Wiring
Wiring the Connectors
The PTE-300 has an RS-232 DB-9 connector, lens control HD-15 high-density connector, 2-pin captive-
screw power connector, and an Ethernet RJ-45 connector.
Always provide enough cable to accommodate the desired range of motion for the
PTE-300 and its camera and lenses. Making a service loop in the cable adequate for
the full range of motion of the camera is highly recommended.
To prevent excessive bending at the connector, attach the Ethernet cable to the Relief Anchor at the
bottom left corner of the PTE-300 (FIG. 21).
Anchor
FIG. 21
PTE-300 Relief Anchor
Camera Control (RS-232 DB-9) Port
The RS-232 DB-9 (male) connector on the PTE-300 connects to the camera head's RS-232 connector.
The following table shows the (DB-9) RS-232 connector wiring diagram.
(DB-9) RS-232 Connector Pinouts
Pin
Signal
1
N/A
2
RXD
3
TXD
4
DTR
5
GND
6
DSR
7
RTS
8
CTS
9
N/A
16
The PTE-300 receives all power from the 24VDC and GND connections on the 2-pin power
connector (refer to the Power Connector section on page 18 for details).
FIG. 1 on page 1 shows the location of the connectors on the PTE-300.
Relief
Function
Not used
Receive data
Transmit data
Data terminal ready (not
used)
Signal ground
Data set ready (not used)
Request to send (output)
Clear to send (input)
Not used
9
5
8
4
3
2
7
1
6
Female
PTE-300 PosiTrack Ethernet Camera Controller
9
8
7
6
Male
Advertisement
Table of Contents
