Table of Contents
Advertisement
Pre-Installation
Overview
The following tools are necessary for installation of the PTE-300:
Necessary Tools
3/32 HEX KEY
3/16 HEX KEY
5/64 HEX KEY
3/32 HEX KEY
Joyswitch or Local Control
The PTE-300 uses a lens control "joyswitch," accessible through the main access hole in the back of the
device (FIG. 8), which allows the installer to control pan, tilt, zoom, and focus locally. This way, when
an installer is connecting wiring in an inaccessible or possibly hazardous location, such as atop a ladder,
the installer does not need to leave the site and go to the control room to see if the connections are
correct.
Main Access Hole
FIG. 8
Location of Joyswitch Access Hole
The lens control joyswitch (FIG. 9) contains 5 switches. Moving it left and right relative to the top of the
device controls pan; moving it up and down controls tilt. Pressing in the center of the switch puts the
joyswitch in lens control mode, where moving the joyswitch left and right adjusts zoom, and moving the
joyswitch up and down adjusts focus. Pressing in the center switch again puts it back into pan/tilt control
mode. The PTE-300 will automatically exit local control mode if the joyswitch is not used for 10
seconds. When the PTE-300 is being controlled locally via the joyswitch, communications from the
Netlinx master are ignored.
FIG. 9
Lens control joyswitch (main access hole)
PTE-300 PosiTrack Ethernet Camera Controller
Camera Alignment Peg
Camera Mount Screw
Tilt Arm Screws
Camera Mount ADJ. Screws
Joyswitch
LED
LED1
Pre-Installation
7
Advertisement
Table of Contents
