Table of Contents
Advertisement
If you hear noise or interf e rence when using the phone:
•
Make sure the base antenna is fully upright.
•
You may be out of range. Move closer to the base.
•
Press and release
available. If noise is exceptionally loud,move closer to the base before
changing channels.
•
Household appliances plugged into the same circuit as the base can
sometimes cause interference. Try moving the appliance or the base
to another outlet.
•
Using the handset near household appliances (microwaves,computers,
television,stereos,etc.) can sometimes cause interference. Move away
from appliances while using the handset.
•
The layout of your home or of fice might be limiting the operating
range. Try moving the base to another location,preferably on an
upper floor.
•
If the buttons don't work,try placing the handset in the base for at
least 15 seconds.
If you hear other calls while using your phone:
•
Press
•
Disconnect the base from the modular jack and plug in a corded
telephone. If you still hear other calls,the problem is probably in
your wiring or local service. Call your local telephone service
company.
If you lose a call after changing channels:
You were probably almost out of range. Move closer to the base before
changing channels. Before placing another call,set the handset in the
base for at least 15 seconds.
If you are unable to operate special telephone services or other
equipment requiring touch tone signals:
If you have dial pulse (rotary) service, follow the directions under
"Temporary Tone Dialing"in the TELEPHONE OPERATION section of
this manual.
If the MESSAGE light on the base does not go off even after you've
listened to voice mail messages:
1
Press
2
Press
until the screen displays
3
Press
4
Press
IN CASE OF DIFFICULT Y
to change to another of the 30 channels
to change to another channel.
.
. The screen displays
again to turn off the MESSAGE light on base.
.
.
21
Advertisement
Table of Contents
