Table of Contents
Advertisement
Table 2-2. Setup Console Redirection Submenu Items
Submenu Item
Flow Control
Terminal Type
Serial Port
Remote Console Reset Enabled/Disabled
ACPI OS Headless
Operation
ACPI OS Baud Rate
ACPI OS Flow Control No Flow Control
ACPI OS Terminal
Type
Default Value
Description
No Flow Control
No flow control.
[CTS/RTS]
CTS/RTS = Hardware-based flow control.
CTS/RTS + CD
CTS/RTS +CD = Hardware-based + carrier-detect flow
control. When the BMC Management Utility is sharing
XON/XOFF
the COM port as console redirection, the flow control
must be set to CTS/RTS or CTS/RTS+CD depending
on whether a modem is used.
Xon/Xoff = Software-based flow control.
[PC-ANSI]
Select terminal type. VT100+ only available when
English selected as the language. VT-UTF8 uses
VT100+
UNICODE. PC-ANSI is the standard PC-type terminal.
VT-UTF8
COM2 2F8 IRQ3
Hardcoded – no selection available. Note that if Console
Redirection is enabled, then the Base I/O address and
IRQ selection of Serial Port B (under Menu Advanced,
submenu Peripheral Configuration) should match this
Serial Port setting under the Console Redirection
submenu.
Enables remote reset using escape key sequence;
<ESC> <R> <ESC> <r> <ESC> <R>
Disabled
Used to pass information about serial redirection to
ACPI OS.
Same as BIOS
Serial Port
9600
Only available when ACPI OS Headless Operation is
same as BIOS or Serial Port.
19.2k
38.4K
57.6k
115.2k
Only available when ACPI OS Headless Operation is
same as BIOS or Serial Port.
CTS/RTS
XON / XOFF
CTS/RTS + CD
PC-ANSI
Only available when ACPI OS Headless Operation is
same as BIOS or Serial Port.
VT100+
VT-UTF8
(continued)
Configuring Your Managed System
15
Advertisement
Table of Contents
