Advertisement
4.) The last item under the "Control Option" menu is "Sender Setting". (Refer to Figure 14)
The SAPS software makes it possible to automatically send an e-mail message
containing information concerning errors to a pre set e-mail address should projector errors be detected.
The "E-mail Server (SMTP Server) line is where the actual IP address of your mail server is placed.
(Contact your IT / MIS group for the proper Server IP address)
The "Sender E-mail Address" is the Administrators e-mail address as defined by the Network
Administrator . (your E-mail address on the company Server)
The "Sender Name" is your name.
Figure 14
"Sender Infromation" allows you to add your general comments to any e-mail sent out.
This concludes the S.A.P.S section on Network Setup. Assuming that all the information is correct
and all the following steps were followed, the last item is to Scan the network for the existing
projector(s) which was just setup.
The "Scan Setting" once again is under the "File" menu of the "Multiple Control" screen
of the S.A.P.S. software. (Refer to Figure 5 for detailed screen image on page 10 )
16
10/16/2001
L:\tekcentr\CACTrain\SPS_ntwk
Advertisement
