Manually Setting Stations Into Memory; Preset Station Scan - Eclipse CD5425E Owner's Manual

ATTENTION
• Pressing the preset buttons ([1] to
[6]) allows you to make one-touch
station selections. The frequency
of the selected station is indicated
on.
• When a new station is set in
memory, the station previously set
in memory will be deleted.
• If there are
receivable stations, the stations
set in the remaining buttons will be
retained.
CAUTION
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in the memory
again.
Manually setting stations
into memory
This section covers the setting of stations in
memory under the numbered buttons.
Press the [FM AM] button for less
1
than one second.
You can switch the mode to desired
one.
Turn the [SEL] button to the right
2
or left to tune to the station to be
entered in memory.
fewer than six
Select any button, from [1] to [6],
3
and press it for more than two
seconds.
The tuned
memorized and set in the button
selected. Repeat the procedure to
set additional
stations in memory, in turn, for
buttons [1] to [6]. These buttons
are called the preset buttons.
CAUTION
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in memory
again.

Preset station scan

This function enables reception of all the
stations in the preset buttons for five seconds
each.
Press the [SEL] button for less
1
than two seconds.
[P SCAN] will appear on the
display, and stations stored under
preset buttons [1] through [6] will
be played for five seconds each.
To stop the preset scan mode at a
2
desired station, press the [SEL]
button again.
The receiver will stay tuned to the
desired station.
93
How to operate the tuner
station is
manually tuned
now
VI