Tuning To A Station; Entering Stations Into Memory Automatically (The Automatic Preset Mode: Asm) - Eclipse CD5425E Owner's Manual

Operation
ATTENTION
• If stations have been stored in
memory, pressing a button from [1]
to [6] will directly select a station.
(Refer to
stations into memory" on page 93)

Tuning to a station

First, press the [FM AM] button to start tuner
operation.
There are automatic and manual methods for
setting stations in memory. The receiver will
accept up to 30 stations in memory: 6 in AM
(MW), 6 in LW and 18 in FM (6 each for FM1,
FM2 and FM3.) (Initial setting)
Press the [FM AM] button for less
1
than one second to switch to the
desired FM, AM (MW) and LW
bands.
Radio bands will switch from FM1 ➔
FM2 ➔ FM3 ➔ AM (MW) ➔ LW in
order each time the button is
pressed.
Turn the [SEL] button to the left or
2
right to tune to a station.
Turn to the right:
Tunes to higher frequencies.
Turn to the left:
Tunes to lower frequencies.
"Manually setting
Press the [
3
start the
button:
[ ]
Starts searching toward higher
frequencies.
button:
[ ]
Starts searching toward lower
frequencies.
ATTENTION
At times, it may be difficult to maintain
optimum reception because the antenna
affixed to your vehicle is in motion
constantly
antenna), encountering continuous variation
in the received radio signals' strength. Other
factors affecting
interference from natural obstacles, sign
posts, etc.
Entering stations into
memory automatically
(The automatic preset mode:
ASM)
Press the [FM AM] button for less
1
than one second.
You can switch the mode to
desired one.
Press the [SEL] button for more
2
than two seconds until a beep is
heard.
The automatic preset mode starts.
The [ASM ON] indicator on the
screen flashes, and stations are
automatically entered in memory
under buttons [1] to [6].
These buttons are called preset
buttons.
92
] or [ ] button to
automatic station
(relative to the broadcast
reception include