Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 53

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Note
Workaround: Before you install Fabric Manager, Fabric Manager Server, and Device Manager when
using Microsoft Terminal Server in Application mode, you must install the application for global use.
This is required when a Service is installed and invoked, and when creating a local dbadmin user. To
activate this setting, do the following:
CSCso63465
•
Symptom: FCP-CMD (for example, Inquiry) frames targeted to LUN 0x45F0 or LUN 0x50F0 are
dropped by an MDS switch when traffic flows (egresses) through Generation 2 modules. LUN
0x45F0 corresponds to HPUX Volume Set Address <VBUS ID: 0xB, Target ID: 0xE, LUN: 0x0>.
Workaround: Do not use LUN 0x45F0 and LUN 0x50F0 when Generation 2 modules are present
in the fabric.
CSCsq20408
•
Symptom: After creating SANTap Control Virtual Targets (CVTs) or SANTap Data Virtual Targets
(DVTs), the running-configuration and the startup-configuration are not synchronized. Output from
the show startup-config command will be different from the output of the show running-config
and the startup configuration will not display SANTap configuration information.
Workaround: Issue the copy running-startup command whenever you create SANTap Control
Virtual Targets (CVTs) or SANTap Data Virtual Targets (DVTs) so that the running configuration
and the startup configuration are synchronized.
• CSCsq54455
Symptom: On a DS-X9032 module where the SRAM parity error was seen, the SRAM parity error
exceptions were logged continuously.
Workaround: None.
CSCsq57352
•
Symptom: After upgrading from Fabric Manager Release 3.0(2a) to Fabric Manager
Release 3.2(3a), the Fabric Manager client fails to reuse the map layout files produced by Release
3.0(2a). Renaming the map layout files will make them compatible with Fabric Manager Release
3.2(3a).
OL-14116-10
This applies only to Terminal Server running in Application Mode. This issue does not affect
users running a Terminal Server or Remote Desktop session in Remote Administration
mode.
Before running the installation script from the Fabric Manager Installation CD, open a
1.
command-line prompt: Start > Run, then type cmd and press Return.
At the command prompt type: user /install.
2.
Do not close the command line window. This must remain open for the entire duration
Note
of the install.
Follow all steps needed to install Fabric Manager, Fabric Manager Server, and Device Manager.
3.
When the installation is complete, at the command prompt, type user /execute and press
4.
Return. Then type exit.
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2)
Caveats
53