Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 48

Caveats
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
CSCse47687
•
Symptom: If IP ACLs are applied to any IP Storage Gigabit Ethernet port, implicit deny does not
take effect.
Workaround: Configure explicit deny on the port.
CSCsg19148
•
Symptom: Time zone changes that are executed on an MDS switch do not take effect on the 12-port,
24-port, and 48 port 1-Gbps/2-Gbps/4-Gbps Fibre Channel modules, and on the 4-port 10-Gbps
module. This issue occurs in SAN-OS Releases 3.0(1), 3.0(2), 3.0(2a), and 3.0(3).
Time zone changes that are executed on an MDS switch do not take effect on the 16-port or 32-port
1-Gbps/2-Gbps module, on the 4-port or 8-port Gigabit Ethernet IP services module, the MPS-14/2
module, and on the SSM. This issue occurs in SAN-OS Release 3.0(3).
This issue has no effect on functionality. However, debug messages and syslogs from the MDS
switching modules have incorrect timestamps if the time zone is configured on an MDS switch.
Workaround: None.
CSCsg19303
•
Symptom: Graceful shutdowns of ISLs are not supported for IVR traffic.
Workaround: Increase the FSPF cost on the link before it is shut down, so that traffic will flow
through an alternate path.
CSCsi66310
•
Symptom: The management port on MDS switches supports one user-configured IPv6 address, but
does not support autoconfiguration of an IPv6 address in Cisco SAN-OS Release 3.2(1).
Workaround: None.
CSCsj24904
•
Symptom: On a Gigabit Ethernet interface on an MDS MSM-18/4 module, shut the interface before
removing its IP address so that configuration changes on the interface can take effect. This applies
only to the Gigabit Ethernet ports in slot 1 of the MDS 9222i switch and the MDS 9216i switch.
Workaround: Always shut the interface using the shutdown command before removing the IP
address and making configuration changes.
CSCsj72666
•
Symptom: In certain conditions, an MDS switch may not be able to determine the FC4-type of
certain targets. This causes the targets to be listed in the hosts section during a Cisco SME tape group
or tape device configuration.
Workaround: Issue the discover scsi-target vsan vsan-id fcid fcid command to re-discover the
FC4-type of the targets. A Cisco SME tape group or tape device configuration will now list the
targets correctly.
• CSCsk06186
Symptom: In rare situations, on an MDS 9513 director switch, an upgrade fails when a standby
supervisor does not come up to a state that the installer recognizes. As a result, the standby
supervisor is reloaded to recover and the system runs the older configuration version.
Workaround: Perform the upgrade again.
CSCsk35725
•
Symptom: Fabric Manager takes 2 to 3 minutes to bring up the DMM job creation wizard in a setup
with 25 switches, 400 enclosures, and 2400 entries in the name server.
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2)
48
OL-14116-10