Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 47

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
CSCso41087
•
Symptom: If FCIP is enabled and the SAN-OS is upgraded, the SNMP service will run into
exception and the following syslog message is displayed:
setting error index
Workaround: Disable FCIP during the SAN-OS upgrade.
• CSCsq29607
Symptom: After logging back into Fabric Manager Client, clicking on the Summary tab causes a
disconnect.
Workaround: Exit from Fabric Manager Client then restart Fabric Manager Client and log in again.
• CSCsq44360
Symptom: When the startup rising alarm is triggered, the sample value is smaller than the rising
threshold. This should not trigger an alarm.
Workaround: None.
• CSCsq78868
Symptom: Flow statistics on a Generation 2 module may not be accurate if any of the flows that
participate in flow statistics on the module have multiple FSPF paths.
Workaround: For all flows that have flow statistics configured on that module, make sure there is
only one available FSPF path. Use port-channel instead of multiple links to achieve more bandwidth.
• CSCsr22782
Symptom: On Solaris 8, 9, and 10 and RedHat Linux AS4 (kernel version 2.6) the Fabric Manager
Release 3.4(1) installer displays a warning message indicating that it is an unsupported platform.
This occurs even though these platforms are supported.
Workaround: Ignore the warning message and click Continue.
CSCsr89410
•
Symptom: An FCIP link may flap due to a watchdog timeout condition when FCIP Tape
Acceleration is running inSAN-OS Release 3.3(1c).
Workaround: Disable FCIP Tape Acceleration.
CSCsr92585
•
Symptom: An FCIP link running with Tape Acceleration may flap when the host is attempting
SRR/REC tape error handling.
Workaround:None. If link stability is needed, disable FCIP Tape Acceleration.
CSCin95789
•
Symptom: When you configure Cisco Traffic Analyzer to capture traffic on one or more interfaces
on a Windows platform, the configuration web page might not show that the interface has been
selected for traffic capture even though traffic capture on that interface is enabled.
Workaround: Check the logs to clarify that the correct interface has been selected.
CSCse31881
•
Symptom: If there are IP over Fibre Channel (IPFC) interfaces configured on an SSM, you might
experience issues if you downgrade from SAN-OS Release 3.x to Release 2.x.
Workaround: Before downgrading, remove the IPFC interface on the module and then recreate the
IPFC interface after the downgrade is complete.
OL-14116-10
.
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2)
SNMP Operation(165) failed (62)
Caveats
47