Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 36

Caveats
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Workaround: This issue is resolved.
CSCsm39302
•
Symptom: There is a decrease in the FCIP tunnel throughput when IPSec is configured.
Workaround: This issue is resolved.
CSCsm90294
•
Symptom: Certain XSS and XSRF vulnerabilities were found in the Fabric Manager web client.
Workaround: This issue is resolved.
CSCso65297
•
Symptom: Though the INTEGER is defined as (-2147483648..2147483647) in SNMPv2-SMI, the
range is restricted to a 16Bit value 231 -1 = 2147483647 in the msgId field of the SNMP PDU (as
seen in RFC3412).
In the SAN-OS SNMP stack implementation, the agent can potentially return the entire range of
INTEGER as the value of msgId before it starts rolling over. This applies to all SNMP notifications
generated from MDS switches. This is seen in SAN-OS Release 2.x and 3.x releases.
Workaround: This issue is resolved.
CSCso83944
•
Symptom: After the first 200 RMON alarms, the SNMP process will start leaking small amounts of
memory for each alarm. This eventually causes the SNMP process on the Supervisor module to
reach its maximum memory allocation and fail. The Supervisor module will automatically be
restarted by SAN-OS. In rare cases, part or all of the SNMP or RMON configuration may be lost. If
the SNMP process fails quickly in succession, the active Supervisor module may also reset. If there
is a redundant Supervisor module, this will result in a Supervisor switchover.
This occurs only when many RMON alarms are being generated. the SNMPD process may take
seconds to hours to fail, depending on the rate of RMON alarms.
This is seen after a SAN-OS upgrade or after RMON alarms have been configured.
Workaround: This issue is resolved.
CSCso87408
•
Symptom: A scheduled web report fails to generate when the fabric is deleted from Fabric Manager.
The log records Fabric not found fabricID=xxx.
Workaround: This issue is resolved.
CSCsq15255
•
Symptom: The output of the show role session status command might not have the correct time for
the last roles in the CFS session.
Workaround: This issue is resolved.
CSCsq17480
•
Symptom: A Supervisor 2 module running on an MDS 9500 switch will reload with Watchdog
Timeout reason listed as:
`show system reset-reason`
----- reset reason for Supervisor-module 7 (from Supervisor in slot 7)
---
1) At 363570 usecs after Tue May
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2)
36
Reason: Watchdog Timeout
Service:
Version: 3.2(2c)
6 01:21:22 2008
OL-14116-10